Crimping

Eskom’s 14 coal plants regularly break down, exacerbating rotational power cuts of as long as 12 hours a day that are crimping economic growth.

A final decision on any restrictions must be made by the cabinet, and many ministers may be wary of crimping people’s holiday plans, especially with early elections likely on the horizon.

Back in 2011, flooding in that killed hundreds of people also hit factories that created computer hard drives, crimping supply and driving up costs for consumers in developed countries.

Given a labor shortage in the construction sector, extra public works spending would simply reduce the availability of scarce workers for the private sector, crimping output there.

Put 1 heaping tablespoon of filling in the center and gather the ends together, crimping shut so the filling doesn’t come out.

Looking at the current trends across the Corner Crimping Machine market, a new study has been included to the wide database of Market Research Hub (MRH).

With crude prices at levels not seen since late 2014, Allardyce warned the high fuel costs could start crimping consumption.

Dies for bottle neck cases usually are supplied in sets of at least two dies, though sometimes a third is added for crimping.

However, at impact velocities above roughly convert, it may yaw and then fragment at the cannelure (the crimping groove around the cylinder of the bullet).

It was eventually added for effective crimping to ensure that the projectile would not move back into the case and cause a malfunction during auto-load feeding.

Rimless, straight wall cases, on the other hand, require a taper crimp, because they headspace on the case mouth; roll crimping causes headspacing problems on these cartridges.

Special crimping dies are often used to apply a stronger crimp after the bullet is seated.

The neck of the case, if it becomes too brittle, will be incapable of standing the strain of resizing, expanding, crimping, and firing, and will split during loading or firing.

Three dies are normally supplied for straight walled cases, with an optional fourth die for crimping.