Multiplexer

An inverse multiplexer is the opposite of a multiplexer which divides one high-speed link into multiple low-speed links.

Often, a multiplexer and demultiplexer are combined together into a single piece of equipment, which is usually referred to simply as a "multiplexer".

One use for multiplexers is cost saving by connecting a multiplexer and a demultiplexer together over a single channel (by connecting the multiplexer's single output to the demultiplexer's single input).

The transmitting multiplexer also adds additional bits in order to allow the far end receiving multiplexer to decode which bits belong to which data stream, and so correctly reconstitute the original data streams.

The Sanders campaign’s confidence in its technical superiority is partly thanks to a new in-house program called the Multiplexer, which automatically sets up texting campaigns based on voter and volunteer data.

Tmux is a terminal multiplexer that allows running multiple sessions in the same terminal window by splitting the terminal screen.

A customer who orders a DS3 usually receives a SONET circuit run into the building and a multiplexer mounted in a utility box.

Add-drop multiplexer Add-drop multiplexers (ADMs) are the most common type of network elements.

Also, the byte-multiplexer channels on larger models had an optional selector subchannel section that would accommodate tape drives.

A multiplexer is also called a data selector.

A multiplexer is often used with a complementary demultiplexer on the receiving end.

An alternative to an inverse multiplexer is to use three separate links and load sharing of data between them.

An electronic multiplexer makes it possible for several signals to share one device or resource, for example one A/D converter or one communication line, instead of having one device per input signal.

An inverse multiplexer differs from a demultiplexer because the multiple output streams from the former stay inter-related, whereas those from the latter are unrelated.

An SAI may also contain a Digital subscriber line access multiplexer (DSLAM) supporting DSL service.

Any Boolean function of n variables and one result can be implemented with a multiplexer with n selector inputs.

A way you can mark number as positive or negative without using a multiplexer on each bit is to use a XOR (Exclusive OR) gate to precede each bit instead.

Block multiplexer channels could operate as a selector channel to allow compatible attachment of legacy subsystems. citation Basic hardware components Many SLT cards plugged into an SLT board.

Devices connected to a byte-multiplexer channel were configured to operate in 1-byte, 2-byte, 4-byte, or "burst" mode.

DSL Connection schematic Example of a DSLAM from 2006 Exchange equipment At the exchange, a digital subscriber line access multiplexer (DSLAM) terminates the DSL circuits and aggregates them, where they are handed off to other networking transports.