Resistive in a sentence

Circuit In the monostable multivibrator, the one resistive-capacitive network (C 2 -R 3 in figure 1 of Multivibrator ) is replaced by a resistive network (just a resistor).

Extensions ; Resistive : Resistive MHD describes magnetized fluids with finite electron diffusivity ( ).

Resistive instabilities Resistive instabilities are an issue for all magnetic configurations, since the onset can occur at beta values well below the ideal limit.

Strong plasma rotation can stabilize resistive wall modes, as demonstrated in tokamak experiments, and rotational shear is also predicted to stabilize resistive modes.

The output voltage of the switched-on transistor Q1 changes rapidly from high to low since this low-resistive output is loaded by a high impedance load (the series connected capacitor C1 and the high-resistive base resistor R2).

The red streamlines in the tube are now augmented by the oscillatory flow in the tube, a superposition of resistive and reactive dipole flow and resistive acoustic flow.

To overcome the energy demands of resistive magnets, scientists are developing hybrid and superconducting magnets that use less power.

In a victim impact statement, the special constable said: 'Even though I expect an element of resistive behaviour, I do not expect anyone to physically assault me in my line of duty.

Low raw material prices has been witnessed to compliment usage of light-weight corrosion resistive metal stamping for enhancing stability of electrical & electronic and consumer electronic products.

I bought some burn prevention elixirs and completed the quest en route to getting some resistive armour.

Analysis of resistive circuits is less complicated than analysis of circuits containing capacitors and inductors.

A new proposal to stabilize resistive wall modes by a flowing liquid lithium wall needs further evaluation.

Any load mismatch behind the filter can only act on the first harmonic current waveform, clearly only a purely resistive load makes sense, then the lower the resistance, the higher the current.

At extremely high voltages, more than 2,000 kV exists between conductor and ground, corona discharge losses are so large that they can offset the lower resistive losses in the line conductors.

At high frequencies, a dielectric can have a significant resistive loss.

By charging the transmission line and then discharging it into a resistive load, a rectangular pulse equal in length to twice the electrical length of the line can be obtained, although with half the voltage.

Carbon film Carbon film resistor with exposed carbon spiral (Tesla TR-212 1 kΩ) A carbon film is deposited on an insulating substrate, and a helix is cut in it to create a long, narrow resistive path.

Different types of these include: ;Resistive-capacitive (RC) coupled amplifier, using a network of resistors and capacitors :By design these amplifiers cannot amplify DC signals as the capacitors block the DC component of the input signal.

Engine block heaters (electric resistive heaters in the engine block) connected to the utility grid are used in cold climates when an engine is turned off for extended periods (more than an hour), to reduce startup time and engine wear.

For a lossless line, R and G are both zero, so the equation for characteristic impedance derived above reduces to: : The above expression is wholly real, since the imaginary term j has canceled out, implying that Z 0 is purely resistive.