Signal in a sentence

Great Danger Signal-08 (GD-08) has been replaced by Local Cautionary Signal No. 3 (LC-3) at Gopalpur port in Odisha.

AC bias is the addition of an inaudible high-frequency signal (generally from 40 to 150 kHz ) to the audio signal.

A causal paradox can then be constructed by sending the signal if and only if no signal was received previously.

These people sitting there in the stands, looking at the signal, writing it down and matching up the 1st and 10 signal.

Mobile phone signal boosters for other carriers are used if the signal reception in a particular area is weak.

Amplitude modulation produces an output signal that has twice the bandwidth of the original baseband signal.

On its own, the NR4 signal isn’t a “surefire” breakout signal – I have more faith in NR7 or ID/NR4 signals.

A brute force method based on the signal processing definition can be used when the signal size is small.

As of posting, Signal No. 4 is currently raised over Batanes, while Signal No. 3 is up in the northeastern portion of Cagayan.

ADCs are chosen to match the bandwidth and required signal to noise ratio of the signal to be quantized.

Analog vocoders typically analyze an incoming signal by splitting the signal into a number of tuned frequency bands or ranges.

A T-1 trunk could transmit 24 telephone calls at a time, because it used a digital carrier signal called Digital Signal 1 (DS-1).

The signal is thus 100 times stronger, and a small temperature difference gives a strong signal.

They are now referred to as traffic signal preemption or traffic signal prioritization devices.

The striking vehicle was determined to have had the right-of-way with a green signal while the pedestrian signal indicated not to cross.

Within satellite uplink amplifiers’ signal linearization is critical since it produces a significantly cleaner signal from the amplifier.

A digital audio system starts with an ADC that converts an analog signal to a digital signal.

An FM signal can also be used to carry a stereo signal; this is done with multiplexing and demultiplexing before and after the FM process.

Materials for the signal at FM 2499/Robinson have been received and the subcontractor has been scheduled for mid-March to install the signal.

As a result, an electronic backend ADC, that would have been too slow to capture the original signal, can now capture this slowed down signal.