Soldered

The remaining solder types are used in decreasing order of hardness during the process of making an item, to prevent a previously soldered seam or joint desoldering while additional sites are soldered.

And you can choose between soldered key switches or hot-swappable.

We're really eager to see what angle AMD takes in marketing these chips; they're assuredly soldered-down BGA processors, so will AMD emphasize the Macbook head-to-head?

When you buy a laptop, a PC maker will install memory: sometimes soldered on, sometimes with slots that allow more memory to be added in the future.

You get up to 32GB of RAM, but unfortunately this is soldered to the mainboard and not upgradeable.

The PCB is black in color, with the MLC NAND flash memory soldered onto it.

The switches are self-contained units, socketed instead of soldered.

In an early recycling program, flattened SPAM cans were soldered on airplane bomber wings and fuselages to cover and patch bullet holes created by enemy bullets.

Additionally the cartridge adapter had to be opened and soldered in order to allow the operational procedure described early on this article.

A disadvantage of aluminum is that it is not easily soldered, and so connections are instead often crimped together and sealed.

After that period, copper piping took over, first soft copper with flared fittings, then with rigid copper tubing utilizing soldered fittings.

A high-power part pre-tinned with an alloy of lead can therefore desolder under load when soldered with a bismuth-containing solder.

Between the blocks, and soldered or brazed to them, are one or more strips of low temperature coefficient of resistance (TCR) manganin alloy.

By using the hard, high-melting point solder first, followed by solders with progressively lower melting points, goldsmiths can assemble complex items with several separate soldered joints.

DIP header blocks on to which discrete components could be soldered were used where groups of components needed to be easily removed, for configuration changes, optional features or calibration.

Early 20th-century carbon composition resistors had uninsulated bodies; the lead wires were wrapped around the ends of the resistance element rod and soldered.

For low temperatures, junctions can be brazed or soldered, however it may be difficult to find a suitable flux and this may not be suitable at the sensing junction due to the low solder melting point.

If the soldering time is long enough to form the intermetallics, the tin surface of a joint soldered to gold is very dull.

In most cases, such RAM was fixed in size and was soldered to the logic board.

Layers of intermetallics can form between the solder and the soldered material.