Wetted

The principal difference between raw and tanned hides is that raw hides dry out to form a hard, inflexible material that, when rewetted (or wetted-back) putrefy, while tanned material dries to a flexible form that does not become putrid when wetted-back.

Place these on a wetted baking sheet (or sheets); puff pastry rises more easily and crisply, oddly enough, with the help of rising steam.

The Bureau of Meteorology warned the high chance of storms and showers, combined with "wetted up" catchments following a weekend of torrential rainfall, would likely cause localised flooding and disrupt transport routes.

Though it’s not necessary to wield a piping bag – you’ll be pleased to know Hopkinson deploys two wetted spoons – it will yield more even results.

A pipe cleaner can be used to dry out the bowl and, wetted with alcohol, the inner channel.

At the simplest level, the process of composting simply requires making a heap of wetted organic matter known as green waste (leaves, food waste) and waiting for the materials to break down into humus after a period of weeks or months.

A wetted small sponge, often supplied with soldering equipment, can be used to wipe the tip.

However, their relatively greater total wetted area increases frictional resistance and total resistance at low speeds.

Liquids tend to wet the surface of the packing and the vapors pass across this wetted surface, where mass transfer takes place.

The dynamic lift reduces the wetted surface and therefore also the drag.

The resulting supple, suede-like hide is usually smoked heavily to prevent it from returning to a rawhide state, if wetted.

The rounded sections gave maximum displacement for the lowest wetted surface area, similar to a modern narrow rowing skiff, so were very fast but had little carrying capacity.

The shaping of SC blade sections however, make it inefficient at low speeds, when the suction side of the blade is wetted.

The wetted materials in a valve are usually identified also.

To reduce resistance and therefore increase the speed for a given power, it is necessary to reduce the wetted surface and use submerged hull shapes that produce low amplitude waves.

When gasoline is not stored correctly, gums and solids may be created, which can corrode system components and accumulate on wetted surfaces, resulting in a condition called "stale fuel".